Back
How to make blob: 1
Written By: QW-761
Reference
First: acquire roughly 4500 mols of miasma at absolute zero. This can be done using the Hypertorus Fusion Reactor.
Next, make 3 walls around one point, and then where you would put the fourth wall, place a holofan projection there. Afterwards, surround the chamber with field generators, wrench and weld them down. Place emitters adjacent to the field generators, and similarly wrench and weld them.
Then, wire up all of the emitters, making sure the emitters sit on an exposed wire end. There should be multiple sources of power for the emitters, otherwise the field generators may lose power if an emergency occurs.
Finally, put an injector in the middle of the chamber, turn it on and set the output pressure to maximum. Make sure the pipes go out of the containment area, and then put a manual valve and a connector. Connect your canister of miasma there.
When you are ready, call in the supermatter shard where the connector is, then immediately move away, so that you are not crushed by the pod. Then, secure the
Next, make 3 walls around one point, and then where you would put the fourth wall, place a holofan projection there. Afterwards, surround the chamber with field generators, wrench and weld them down. Place emitters adjacent to the field generators, and similarly wrench and weld them.
Then, wire up all of the emitters, making sure the emitters sit on an exposed wire end. There should be multiple sources of power for the emitters, otherwise the field generators may lose power if an emergency occurs.
Finally, put an injector in the middle of the chamber, turn it on and set the output pressure to maximum. Make sure the pipes go out of the containment area, and then put a manual valve and a connector. Connect your canister of miasma there.
When you are ready, call in the supermatter shard where the connector is, then immediately move away, so that you are not crushed by the pod. Then, secure the